Custom Products

Diaphragm Chucks: Designed to clamp thin wall parts, and minimize distortion. These Chucks can be power operated or manual clamp.
Workstops: Designed with adjustment, to locate workpiece. Workstops can be mounted on the workholding unit or on the Cylinder mounted on rear of machine.
Work Ejector with Coolant Thru: Designed to eject part using pneumatics or springs from the spindle and also have coolant thru capability. The Assembly can be mounted in the workholding or behind the cylinder.
Chuck & Cylinder Adapters: Designed to mount Chucks or Cylinder on spindle on any type of Lathe.
Chuck Connector: Designed to connect any type of Chuck to an existing drawtube on any type of Lathe.
Drawtube: Designed to connect the Chuck to the Cylinder, on any type of Lathe.
Live & Dead Center: Designed with special center angle and tapers, to support workpiece.
Face Driver: Designed with special chisel pins and center, to drive and center of workpiece. Face Driver can be mounted directly on machine spindle or as a special cartridge.
Workheads: Designed for 5C, 16C or 3J collet, pneumatic operated (self-contained) and v-belt pulley for motor.
Gages: Designed to check workpiece, they can be designed as hard gage or functional gage.